User Manual
Chapter 2
Hardware Installation
Outdoor Enterprise Access Point WM-OAP8251AG
21
Chapter 2: Hardware Installation
This chapter provides information on how to install the WM-OAP8251AG Outdoor
Access Point hardware.
2.1 Connecting the Access Point
2.1.1 Managed Access Point with Wireless Management Switch
This diagram depicts the hardware configuration.
Follow the instructions below to establish the connection to the Access Point.
1.
Connect one end of the Ethernet Cable into the main LAN Port (PoE) of Managed
Access Point and the other end to the Ethernet Port on the Wireless
Management Switch.
2.
Connect another Ethernet Cable into an Ethernet Port on the front panel of the
WM-OAP8251AG and the other end to the Ethernet Port on the computer.
3.
Screw the provided antennas to the device as shown on the illustration below.
IMPORTANT:
The Access Point supports both IEEE 802.3at PoE (Power over Ethernet)
and the included power injector. You may use either one as the power
source. Do NOT use both at the same time.
