USER MANUAL
CHAPTER 2
GETTING STARTED
20
MILITARY RACK MOUNT PANEL PC
2.3 Configuring Serial Port Settings
Jumpers are located on the motherboard. It is required to open the unit to access the
jumpers. Follow instructions in this section to configure serial port settings.
NOTE
A pair of needle nose pliers may be helpful when working with jumpers.
If you have any doubts about the best hardware configuration for your
application, contact your local distributor or sales representative before
you make any changes. Generally, you simply need a standard cable to
make most connections.
The jumper setting diagram is shown below. When the jumper cap is placed on both pins,
the jumper is SHORT. The illustration below shows a 3-pin jumper; pins 1 and 2 are short.
If you remove the jumper cap, the jumper is OPEN.
SHORT
CAUTION
To avoid damaging the module, always turn off the power supply
before configuring jumper settings.
Both Jumper 8 and Jumper 9 allow setting the Serial Port COM 1configuration.Refer to
the table below for PIN assignment.
Example:
To make RS-232 Settings, set the Jumper 8 Pin 1-2 to the SHORT position, and
Jumper 9 Pin 1-2, 4-5, 7-8, 10-11 to the SHORT position.
Содержание R17IB3S-RKA1ML
Страница 10: ......
Страница 80: ...USER MANUAL CHAPTER 6 BIOS SETUP 68 MILITARY RACK MOUNT PANEL PC...