Winmate R12IBWS-MHM2, Руководство пользователя

Страница: 29 / 74

USER MANUAL CHAPTER 2 GETTING STARTED
M-SERIES HMI 16
2.3 Configuring Serial Port Settings
Serial Port COM1 can be configured for RS-232, RS-422 or RS-485. Jumpers are located
on the motherboard. You need to open the housing in order to access the jumpers.
CAUTION/ ATTENTION
It is recommended to use factory jumper settings. Opening the housing
when it is sealed may damage the device and its parts.
Il est recommandé d’utiliser la configuration d’usine de cavalier. Ouvrir le
chassis lorsqu’il est scellé peut endommagé l’appareil et ses pièces.
Note:
A pair of needle nose pliers may be helpful when working with jumpers. If
you have any doubts about the best hardware configuration for your
application, contact your local distributor or sales representative before
you make any changes. Generally, you simply need a standard cable to
make most connections.
The jumper setting diagram is shown below. When the jumper cap is placed on both pins,
the jumper is SHORT. The illustration below shows a 3-pin jumper; pins 1 and 2 are short.
If you remove the jumper cap, the jumper is OPEN.
PIN 1-2 SHORT
PIN 3 OPEN
The picture below shows RS-232/422/485 (J8/J9) jumper setting.
Example: To make RS-232 Settings, set the Jumper 8 Pin 1-2 to the SHORT position, and
Jumper 9 Pin1-2, 4-5, 7-8, 10-11 to the SHORT position.