Winmate IK32, Руководство пользователя

Страница: 26 / 84

USER MANUAL CHAPTER 2 HARDWARE INSTALLATION
- 26 -
2.2 Memory Module (SO-DIMM) Installation
The IK32 SBC Motherboard has two 260-pin SODIMM slot. The socket supports
DDR4.
When installing the memory unit, please follow the steps below:
1. Firmly insert the SO-DIMM at an angle of about 30-degree into the slot. Align
the SO-DIMM with the slot until it is fully inserted. The notch on the SO-DIMM
should match the break on the slot.
2. Press downwards on SO-DIMM until the retaining clips at both ends fully
snap closed and the SO-DIMM is properly seated.
NOTE:
Pull tabs away with your thumbs, bracing your forefingers against
the rails. The memory module will be released. Then raise the
memory module to a vertical position.
CAUTION
The SO-DIMM only fits in one correct orientation. It will cause
permanent damage to the development board and the SO-DIMM if
the SO-DIMM is forced into the slot at the incorrect orientation.