Winmate IA71, Руководство пользователя

Страница: 16 / 100

IA71 Motherboard User Manual V1.0
6
Chapter 2 Installations
2.1. Installation Precautions
Cautions
The procedures in this chapter assume familiarity with the general
terminology associated with single board computers and with the safety practices
and regulatory compliance required for using and modifying electronic
equipment.
Disconnect the computer from its power source and from any
telecommunications links, networks, or modems before performing any of the
procedures described in this chapter. Failure to disconnect power,
telecommunications links, networks, or modems before you open the computer or
perform any procedures can result in personal injury or equipment damage.
Some circuitry on the board can continue to operate even though the front panel
power button is off.
Follow these guidelines before you begin installing the IA71 Motherboard:
Always follow the steps in each procedure in the correct order.
Set up a log to record information about your computer, such as model,
serial numbers, installed options, and configuration information.
Electrostatic discharge (ESD) can damage components. Perform the
procedures described in this chapter only at an ESD workstation using an
antistatic wrist strap and a conductive foam pad. If such a station is not
available, you can provide some ESD protection by wearing an antistatic wrist
strap and attaching it to a metal part of the computer chassis.
When you install and test the IA71 Motherboard, observe all warnings and
cautions in the installation instructions.
To avoid injury, be careful of:
Sharp pins on connectors or headers
Sharp pins on printed circuit assemblies
Rough edges and sharp corners on the chassis
Hot components (like processors, voltage regulators, and heat sinks)
Damage to wires that could cause a short circuit
Observe all warnings and cautions that instruct you to refer computer
servicing to qualified technical personnel.
Do not overload the power supply output. To avoid overloading the power
supply, make sure that the calculated total current loads of all the modules within