Winmate IA70, Руководство пользователя

Страница: 18 / 111

IA70 Motherboard User Manual V1.1
8
To remove a DIMM, follow these steps:
1. Turn off all peripheral devices connected to the computer. Turn off the computer
and disconnect the DC power cord.
2. Gently spread the retaining clips at each end of the DIMM socket. The DIMM
pops out of the socket.
3. Hold the DIMM by the edges, lift it away from the socket, and store it in an
anti-static package.
4. Reinstall and reconnect any parts you removed or disconnected to reach the
DIMM sockets.
5. Replace the computer’s cover and reconnect the DC power cord.
2.3. I/O Equipment Installation
2.3.1. 12V DC-IN
The Motherboard allows to plug in 12V DC-IN jack on the board without another
power module converter under powered consumption by Intel Atom N270 1.6GHz
processor.
2.3.2. PS/2 Keyboard and PS/2 Mouse
The Motherboard provides two PS/2 interface. The PS/2 connector supports Keyboard
and Mouse. In other cases, especially in embedded solutions, a mouse is not used.
Therefore, the BIOS standard setup menu allows you to select* “All, But Keyboard”
under the “Halt On” item. This allows non-keyboard operation in embedded system
solutions without the system halting under POST.
2.3.3. Serial COM ports
Three RS-232 connectors build in the rear side of I/O ports. Fourth optional COM
ports support RS-232 signal. When an optional touch-screen is ordered with Panel PC,
serial COM port can connect to a serial or an optional touch-screen. One optional
COM port supports RS232/422/485 choice through jumper setting.
2.3.4. Internal VGA
The Motherboard has one VGA port that can be connected to an external CRT/ LCD
monitor. Use VGA cable to connect to an external CRT / LCD monitor, and connect
the power cable to the outlet. The VGA connector is a standard 15-pin D-SUB
connector.