WinGD RT-flex50DF, Руководство по обслуживанию, Страница: 413 / 586

Maintenance
5562 − 3/A1
Winterthur Gas & Diesel Ltd.
3/ 4
4. FLV − Align and
Installation
4.1 Valve Block − Align
1) Make sure that the lip seal (3, Fig. 2 ) is
removed from the FLV.
2) Clean the surface plate (94585A,
Fig. 4 ).
3) Attach the FLV to the surface plate
(94585A). Do not tighten the screws (4,
5) at this step.
4) Loosen the eight bolts (3).
5) Make sure that the eight bolts (3) have
Never Seez applied to the threads.
6) Torque the four screws (4) to 60 Nm.
7) Torque the four screws (5) to 35 Nm.
8) Torque symmetrically in equal steps the
eight bolts (3) to 120 Nm.
9) Remove the FLV from the surface plate
(94585A).
4.2 Installation
CAUTION
Injury Hazard: The weight
of the FLV is approximately
35 kg. Use the correct
equipment to lift and move
the FLV. This will prevent
injury to personnel.
1) Remove the blind flange (94585B,
Fig. 3 ) from the fuel rail.
2) Clean the inlet bores of the FLV (2,
Fig. 5 ).
3) Attach the M10 eye bolts (94045-M10)
to the FLV (2).
4) Lift the FLV (2).
5) Carefully put the lip seal (3) in position
in the FLV (2).
6) Lower carefully the FLV (2) on to the
fuel rail.
7) Apply Never Seez NSBT to the four
M12 screws (4) and the four M10
screws (1).
8) Torque the four M12 screws (4) to
60 Nm.
9) Torque the four M10 screws (1) to
35 Nm.
2016
Flow Limiting Valve: Replacement
1b
7
4
94585A
1a
5
Fig. 4
2
1
3
Fig. 5
3
4 1
2
WCH03116