Reflector
bolt (4)
6
TIP
Bolts are inserted from the back of the
reflector. Washers and nuts are threaded
onto the bolts from the front of the reflector.
FIGURE 9.
Reflector alignment points
Four holes
on reflector
Four holes
on mounting
bracket
FIGURE 10.
Attach reflector with 4 bolts (back of
reflector), washers and nuts (front of reflector)
Torque- Minimum 35 in.-lb. Maximum 50 in.-lb.
Reflector
bolt (4)
Reflector
nut (4)
Painted
washer (4)
Painted
washer (4)
Reflector
nut (4)
SERVICE MODE
WILL RAISE
ANTENNA
CANCEL *CONFIRM
*NORMAL MODE
LOW POWER MODE
TRAVEL MODE
SERVICE MODE
Install the Reflector
(New Install)
When the sealant around the transition plate and cable entry
plate has begun to cure, check that there is nothing above the
unit that might prevent the antenna from raising. Then follow the
instructions to raise the antenna for reflector installation.
1. Once the power cord (48 V DC) is applied to back of the IDU,
the IDU will automatically power on. Powering on the IDU
will not raise the antenna. Please wait until the
READY
state
appears on screen to continue.
2. To access
SERVICE MODE
on the IDU, press and hold
the Power button for three seconds. This will bring up the
SETTINGS MENU
in the IDU.
3. By pressing the Search (up) or Stow (down) button you
can scroll through the available options until the asterisk
is next to
SERVICE MODE
. Pressing the Power button will
confirm your selection.
4. Pressing the Search button (left) or Stow button (right) allows
you to scroll left and right on the cancel and confirm options.
Pressing the Power button will confirm your selection.
5.Once
SERVICE MODE
has been confirmed, the antenna will
automatically raise.
6. Proceed to the roof to install the reflector.
7. Line up the four holes on the reflector with the four holes
on the mounting bracket. Insert a reflector bolt through
one of the four holes on the back of the reflector. Insert one
painted washer and thread a nyloc nut onto each bolt, tighten
the nut to secure the reflector to the mounting bracket,
making sure to tighten the nut until it is flush with the washer.
Overtightening will bend the washer. Repeat process until all
holes are secure. See figure 9 and 10.
8. Once installed, press and hold the Power button for three
seconds to re-enter the
SETTINGS MENU
.
9. With the asterisk next to
NORMAL MODE
, press the Power
button to confirm selected mode. This will leave the satellite
antenna raised and in the ready state.
*NORMAL MODE
LOW POWER MODE
TRAVEL MODE
SERVICE MODE
1
2
3
4
1
2
3
4
WARNING
Entering
SERVICE MODE
will raise the
antenna. Please check for obstructions
prior to selecting
CONFIRM
to enable
SERVICE MODE
.
NOTE
Be sure to tighten an additional quarter turn with
a wrench to confirm proper tourque/tightness.
10. Press Stow on the IDU to initiate the stow sequence.
Once stowed,you are ready to operate your Trav'ler Pro!
