Pull the e-clip off of the pin, and
remove the pin from the leveling
bracket.
2
Existing
Antenna
Assembly
Retrofit
Antenna
Assembly
Leveling
bracket
Pin
Remove the cap from the coax
connection port.
Thread the 140 cm coax between
the boom and the center of the
lower element housing. Continue
to thread the coax in an S-curve
between the boom and the center
of the lower element housing.
NOTE
Make sure that the other end of the 140 cm coax leads to the wall
plate/power supply.
Replacing
a
Winegard
Sensar
HV
Antenna
with
the
Sensar
HV
Retrofit
Kit
1
Mounting
bracket
140 cm coax
Insert the pin through the leveling
bracket and the elevating gear. Push
the e-clip over the end of the pin.
Using a wrench, loosen and remove
the 140 cm coax from the coax
connection port shown here.
Boom
3
Mounting bracket
Remove the existing antenna assembly from the mounting bracket.
Lower element housing
4
Elevating gear
Connect the coax to the coax
connection port, and tighten until
fingertight. Then, tighten ¼ turn
more.
Using the retrofit antenna assembly, insert the elevating gear in-between the
sides of the leveling bracket. The elements should be on top of the boom. The
holes in the sides of the leveling bracket and in the elevating gear should align.
Cap
5
6
7
8
