other channels found at alternate positions. Pressing
the Search button again will move the antenna
to the next best location. Continuing to press
Search again will cycle through other positions that
provided additional channels, until returning to the
main search location.
To clear search results and initiate a new search,
press and hold the Search button for 2 seconds.
The system will also clear all search results each
time it is powered off.
Run a Channel Scan
Using the television remote, select “Menu” and
then “Settings.”
Select “Channel Setup.”
Select “Antenna” or “Air,” depending on your TV.
Make sure you are not on “Cable.”
Select “Channel Search” or “Channel Scan.”
Keep in mind that steps to perform a channel
scan may vary. If the wording in your TV differs
from the options shown, refer to your TV user
manual for help.
Manual Control
The Rayzar Automatic antenna also allows you to
move the antenna with a manual control function.
This can either be used for fine tuning a channel
that may be pixelating, or used as a manual search
method in a known location. Pressing the rotate
buttons will move the antenna in small increments.
The GREEN LED will show the antenna position.
If 2 adjacent GREEN LEDs are lit, the antenna is
positioned half way between the corresponding LEDs
Pressing the search button after using manual controls
will return the antenna to Automatic Search Mode and
move to the next best stored location.
Sleep Mode
While in Antenna Mode, if no buttons are pressed
for 3 minutes, the system will enter into Sleep
Mode. During Sleep Mode the POWER LED will
remain lit and the antenna amplifier will remain on,
allowing you to watch TV. All other LEDs will be
turned off.
To exit sleep mode and resume operation, press any
button on the control panel.
Troubleshooting
While in manual mode, if the readout displays “HS”,
that means the antenna has reached the operational
limit and needs to rotate the other direction.
Pressing the Search and Counter Clockwise Rotate
button at the same time will perform a reset on the
system. This will clear any search results and restart
the system. This can also be used to trouble-shoot
the system, as performing a reset can clear error
messages. Below is a list of possible Error Codes
displayed during operation. The Error Code would
be displayed on the 2-digit readout during use. Refer
to the table below for possible codes and actions to
resolve the errors.
Error CodE
CausE
aCtion
E1
Short in Coax Between
Control panel and
antenna.
Check all cables and
connections then perform
RESET function on control
panel
or disconnect 12V.
E2
No antenna detected.
Check all cables and
connections to antenna.
E3
Motor Movement Error. Antenna may still function.
If problem persists contact
Winegard Technical Service.
E4
Tuner Error. Controls
and antenna will still
function.
Perform RESET function on
control panel. If problem
persists contact Winegard
Technical Service.
E5
Factory Mode.
Perform RESET function to
exit Factory Mode and return
to normal operation.
If the above steps do not resolve the issue or
another persists, please contact Winegard Technical
Service at 1-800-788-4417 or [email protected].
Page 6
Winegard Rayzar Automatic Antenna
1.
2.
3.
4.
5.
