RoadTrip T4 In-Motion Antenna 6
DIRECTV
®
Receiver Setup
(cont.)
DIRECTV
®
Satellite Coverage
Receiver Recommendations
DIRECTV satellite 101°
T4 antenna coverage map
DIRECTV satellite 119°
T4 antenna coverage map
5)
Select
3-LNB (18”x 20”)
or
3 Satellites
.
If given the option of SWM or Multi-switch, select
Multi switch
.
Power on the antenna, and allow the antenna a few
minutes to acquire signal. Once the antenna has
finished acquiring signal, the antenna will be silent.
6)
After the antenna has acquired signal, press
Continue
.
The receiver will automatically verify the setup.
8)
Select
Continue
again
The program guide will download.
9)
When the status bar reaches 100%, press
Continue
.
10)
The receiver will run Data Feed and Guide Feed Tests
for a few moments.
When prompted to set up the remote, select
Setup Remote Later
to do this at a later time.
Select
Watch DIRECTV
.
Receiver setup is now complete.
7)
Errors may be displayed on the screen. It is normal
to see one or two boxes with an
X
instead of a
.
Select
Continue
.
Coverage maps are for reference only and do not guarantee coverage.
The RoadTrip
®
T4
antenna will operate with most DIRECTV receivers.
Winegard does not recommend using receivers with hard
drives not recommended by the manufacturer for mobile
applications.
Winegard does not recommend using an HD
receiver since HD programming will not be available.
SWM only receivers require a SWM-840 kit. For more
information contact Technical Services at 1-800-788-4417.
The antenna will locate and toggle between satellites 101°
and 119°. The RoadTrip
®
T4 antenna will not operate in all
areas where satellites 101° and 119° are available.
The T4 antenna is not compatible with 110° or KA-band
satellites 99° and 103°.
Refer to the figure below for an operational coverage map of
satellite 101° and 119°.
Satellite coverage maps are based on level, stationary
operation.
Reception interruption may also occur during
adverse weather conditions.
DIRECTV satellite 101°
&
119° coverage map
