Winegard RM-4610, Руководство пользователя

Страница: 9 / 16

9
FIGURE 13
STEP 19. The directional handle
and threaded rod will fit roofs up to
5-1/4" thick. If you are using
wedges to compensate for roof/
ceiling slope, be sure to allow for
this extra thickness. You may add
an extension to the directional
handle for thicker roofs. Each
extension will increase the length of
the directional handle by 2-1/4".
WITHOUT ROOF
WEDGE
Measure from top
of roof to ceiling.
CEILING
TOP OF
ROOF
³³³³³
³³³³³
³³³³³
³³³³³
WITH ROOF WEDGE
Measure from top
of roof wedge to ceiling.
TOP OF
ROOF WEDGE
CEILING
STEP 20. Press the directional handle onto the
hub. Point the arrow on the directional handle
towards the rotate/lock lever to orient to the
splines.
STEP 21. Install the washer and nut on the
threaded rod. Tighten the nut enough to snug the
directional handle to the hub.
STEP 22. IF YOU ARE USING AN EXTEN-
SION, adjust the total length of the directional
handle and extension by cutting the directional
handle. After adjusting parts for proper roof
thickness, glue the extension to the directional
handle. Use ABS (plastic pipe) glue.
NOTE: For roofs thicker that 5-1/4", a longer
aluminum hex shaft will be needed. Contact
Winegard Company for this part.
CUTTING SHAFT
LENGTH, Figure 14A:
Flip down handle on the
elevating crank handle.
Slide elevating crank
handle up shaft until
snug against directional
handle. Mark the
elevating shaft at
inside bottom surface
of crank handle
housing, Figure 12. Cut
shaft at mark, after
removing crank handle.
Reinstall crank.
STEP 23. Check system for proper operation. Elevate dish with crank handle. A minimum of 14 turns is needed to
elevate dish. Then, move directional handle with dish elevated. Directional handle should turn freely. If possible,
have someone watch to make sure coax does not bind or interfere with dish movement.
Directional
Handle
Threaded
Rod
Hub
Worm
Gear
Spring
Spacer
Ceiling
Plate
Plastic
Plug
FIGURE 14
Cut elevating
shaft at inside
surface of
crank handle
housing; shaft
goes through
hex-shaped
opening by
screw.
Elevating shaft
Crank Handle
FIGURE 14A