Example 3
APPLICATIONS AND
ALTERNATE CONNECTIONS
WARNING: Do not connect high
current devices such as hair
dryers to +12 volt receptacle on
wall plate/amplifier. Maximum
current ratings of this receptacle
is 7.5 amps at +12 VDC.
INSTRUCTIONS
STEP 1.
Select location for wall plate and
outdoor receptacle. Run two coax cables (RG-
59 type) between locations and install
connectors on each end.
Mark cables so
"cable input" and "TV output" may be
identified.
Antenna downlead and +12 VDC
will also be needed at inside wall plate/amplifier
location.
STEP 2.
Refer to outdoor receptacle
instruction sheet on how to install cables and
receptacle. Make sure jack on outdoor
receptacle marked
CABLE INPUT
is attached
to cable going to jack marked
CABLE
on indoor
wall plate/amplifier.
STEP 3.
The wall plate/amplifier assembly
may be flush mounted in most standard
electrical boxes. To flush mount cut a hole in
wall to fit the box. Run 2 #12 wires between wall
plate/amplifier and +12 VDC source and route
downlead cable to this location. Install cable
between set 2 outlet and power supply location
at this time.
WHEN CONNECTING CABLE OR WIRES
BE SURE SWITCH IS IN OFF POSITION.
STEP 4.
Install terminals on wires from +12
VDC source as shown in Figure 1. Crimp
terminals with Craftsman type 4 crimping tool
or equivalent. See Figure 1. Push wires onto
tabs on terminal board as shown in Figure 2. If
in doubt as to the polarity of the wires, connect
them temporarily to tabs on circuit board and
press switch on front of outlet. If light comes on
polarity is correct. See Figure 3.
WARNING: Use this amplifier/
switch with only non-amplified
RV antennas.
Non-Amplified
Antenna
Outdoor Receptacle
WA-1010
TV
Outlet
Antenna
Input
Cable Input
Cable Input
Set 1
Example 1
Outdoor Receptacle
WA-1010
TV
Outlet
Antenna
Input
TG-7221
Cable
Input
Set 2
Set 1
TV-1030
Splitter
Example 2
Antenna
Input
TG-7221
Cable
Input
Set 2
Set 1
ON/OFF
Switch
ON/OFF
Switch
ON/OFF
Switch
Outdoor Receptacle
WA-1010
FIGURE 1
FIGURE 3
WARNING
DO NOT connect high
current devices such as
hair dryers to this
receptacle. Maximum
current rating of this
receptacle is 7.5 amps at
12 VDC.
FIGURE 2
Connector
Insulation
Remove 1/4" of
insulation from
#12 wire.
#12 Wire
1/4"
Connector
Ferrule
Crimp Here
+12 VDC
Ground
Set 2
Non-Amplified
Antenna
Non-Amplified
Antenna
