Figure 13
Figure 12
Figure 11
1
2
3
4
Disclaimer: Although every effort has been made to ensure that the information in this manual is correct and complete, no
company shall be held liable for any errors or omissions in this manual. Information provided in this manual was accurate at
time of printing. If the antenna does not function as expected, please contact Winegard Company at [email protected] or
1-800-788-4417, or visit our website at www.winegard.com.
Receiver Setup for a Secondary Receiver
After completing setup on the main receiver, power on the secondary receiver. If using a new receiver, you will be guided through
the setup by the Installation Wizard; follow the on-screen steps to complete setup. If using a receiver that is currently active or has
been used previously, you will need to complete setup by doing a Check Switch test. To access the receiver menu for running a
Check Switch test, follow the steps under “Accessing the Receiver Menu.”
Accessing the Receiver Menu
If you need to access the receiver menu after initial setup, follow the steps below to reach the receiver menu.
Press “Menu” on your remote. Select option 6, “System Setup.”
Select option 1, “Installation” (see fig. 11). Then, select option 1, “Point Dish” (see fig. 12).
Select “Check Switch” (see fig. 13), and complete the Check Switch test.
Transporting
Before transporting the antenna, return
the antenna to the stowed position. To
stow the antenna, disconnect the coax
cables from the main and secondary
ports, and rotate the antenna until the
elevation arrow aligns with “STOW.”
Do not use excessive force when
manually rotating the antenna, as this
could cause damage to motors and gears.
Maintenance
The Pathway X2 antenna is designed
to be maintenance free. However, it is
a good idea to clean the reflector cover
from time to time. Clean the reflector
cover with a soft cloth, water, and dish
soap to avoid scratching the cover.
Tripod Accessory
Model TR-1518 tripod mount (sold
separately) is available as an accessory
for the Pathway X2 antenna. The tripod
mount has adjustable height and
leveling settings of 14.5”–22” and quickly
disassembles for compact storage.
Troubleshooting
On Screen
Possible Cause
Solution
Mobile Antenna Setup does not appear
• No communication between receiver
and satellite dish
• Check wiring. Verify connection to
Main port. Verify good coax.
• Receiver software not compatible
• Ensure a compatible DISH Solo HD
receiver is being used.
• Connect receiver to fixed/home
satellite dish for software update.
Error Code 150, “All Satellites Not Found”
• Possible obstructions blocking satellite
• Satellite coverage issues in extreme
Northeast or Northwest
• Attempt to move the antenna from
any blockages or obstructions.
• Attempt a re-scan on the receiver.
• Try scanning on a different arc.
Error Code 151, “No Satellites Found”
• Possible obstructions blocking satellite
• Intermittent coax connection
• Attempt to move the antenna from
any blockages or obstructions.
• Re-check coax connections to make sure
coax did not become loose during scan.
• Attempt a re-scan on the receiver.
If the above steps do not resolve the error, re-boot the receiver and start the Mobile Antenna Setup again; often, this will
resolve the problem. If the problem persists, contact Winegard Technical Services at [email protected] or 1-800-788-4417
.
