Assembling the Window Mount
Align the hole in the clip with the press nut at the
top of the the back support. The hole in the clip
should fit around the raised lip of the press nut.
Insert a 10-32 x 1/4
"
screw through the aligned
holes in the clip and back support, and tighten.
Push the two rubber bumpers through the two
holes in the bottom of the back support. Make
sure the rubber bumpers are fully installed before
proceeding, as these will prevent the mount from
scratching the vehicle.
Determine the preferred height of the window
mount base against the back support.
Align the bottom hole in the window mount base
with the preferred hole in the back support. Insert
a 10-32 x 1/2
"
screw through the aligned holes in
the back support and base plate. Tighten.
Before proceeding to the next section, decide
where cables should exit in relation to the mount.
Specifications
For use with the Winegard Carryout G2+ antenna
(Models GM-6000 and GM-6035), Winegard Pathway
X1 antenna (Models PA-2000, PA-2035, PA2000R,
PA2035R), or Winegard ConnecT (Models WF-4000,
WF-4035, WF-3000, WF-3035)
For stationary use only
Height (once assembled): 13.35", Width: 10.25"
Extends 5.75" from vehicle
Adjustable vertical mounting settings every 1.5"
Window clip swivels 90° to easily
level antenna
Mount weight: 2 lbs
•
•
•
•
•
•
•
10.25
"
13
.3
5
"
5.7
5
"
1.
2.
3.
4.
5.
Failure to install in accordance with product
manufacturer’s installation and assembly
instructions could result in property damage,
personal injury, and/or death.
Step 1
Step 2
Step 3
