Winegard Movin' View MV3500A, Руководство пользователя

Страница: 9 / 12

9
Installation
CABLE-
ENTRY
CABLE
CLAMP
1. Decide the best location for the cables to enter
the vehicle, and the location of the power switch
and receiver (see “Installing the switch and
receiver”on pages 9 and 10). Drill a 1/2” hole in the
roof, push wires inside. Make proper connections.
You must have fi12 VDC power source .
2. Place cable-entry plate over hole and cables.
Screw in place. Seal plate and screw holes with ap-
proved sealant (not included).
3. Depending on the length of the cable on the roof,
you may need to use cable clamps or wire ties (not
provided) between the unit and your cable-entry plate.
Clamping the cable every 12”-16” should eliminate
any unnecessary cable movement, Figure 6.
FIGURE 6
Cable entry installation — INSTALLING THE POWER SWITCH
1. Choose a location to install the MV3500A power
ON/OFF switch. Remember when selecting a location
that you will need to run the +12VDC power cable
from the MV3500A to the switch.
Be sure the
switch is in the OFF position before continuing.
See Figure 7 page 9.
Wall or panel mount : Drill 1-1/4” hole, pull wires
through wall or panel.
Surface mount : Determine location and direction of
box. Mount box and feed wire into one of the box open
ings. Snap the rocker switch into the switch plate.
Be
sure switch is off!
2. Connect the ground wire from the vehicle and the
BLACK ground wire from the MV3500A together,
using large yellow flag connector.
3. Connect the YELLOW flag connector to
the silver spade on the switch.
4. Connect the RED wire from the MV unit to the
small RED flag connector.
5. Connect small RED flag connector to center
spade on switch.
6. Connect the +12 V power wire from the vehicle to
a small RED flag connector.
7. Connect small RED flag connect to isolated
spade on switch.
INSTALLING THE POWER SWITCH DIAGRAM
STEPS 2 & 3
TWO GROUND WIRES
1 FROM VEHICLE
1 BLACK WIRE FROM
SATELLITE DISH
STEPS 4 & 5
RED POWER
WIRE FROM
DISH
STEPS 6 &7
+12 V FROM VEHICLE
ON/OFF ROCKER SWITCH
WITH LIGHT
(Shown in OFF position.)
FIGURE 7
INSTALLING THE DOME
Insert screw in holes on dome
rim. Be sure bolt is vertical;
not tilted to side. Tighten to
20 in.-lb., or approximately
until washer is visible
around screw head.
CAUTION:
DO NOT
OVERTIGHTEN!!
QUADREX
SCREW WITH
RUBBER
WASHER
(USE #2
PHILLIPS)
REV. 12/05