7
Sat. Rcvr.
Switch Set Position
1
2
3
4
5
6
7 8
DIRECTV .............................................. 0 .... 0 ... 0 ..... 0 .... 0 ... 0 ..... 0 .... 1
DISH NETWORK .................................. 0 ... 0 ... 0 ..... 1 .... 0 ... 0 .... 1 .... 1
EXPRESSVU ........................................ 0 .... 1 ... 0 ..... 1 .... 1 ... 0 ..... 1 .... 1
Switches preset for
DIRECTV
Switches set for DISH
Network
Switches set for
EXPRESSVU
IMPORTANT! Do not install this system
in the rain, or under any wet conditions
. Mois-
ture may affect electronics and void your
warranty!
1. For best performance and to reduce signal ac-
quisition time, park vehicle on a level surface;
level the RV.
2. Select a level spot on your roof for installation.
Using the chart,
determine the
minimum
distances
to other equipment.
• The unit should be no more than +/-1° off level.
• Be sure no roof-mounted equipment is
blocking the satellite “line of sight”, Fig. 3
• You will need to decide where the wires will enter
the vehicle. A coax and a power wire (minimum 16
gauge) will need to be run into the vehicle. The
power wire will go to the nearest
filtered
+12 VDC
power source; the coax will be routed to your
satellite receiver.
3. Remove screws holding dome to base and re-
move dome. Place dome in safe spot to avoid
damage. Place base on vehicle roof in the loca-
tion selected.
REMEMBER:
REAR MOUNTING FOOT MUST BE PARALLEL
TO THE CENTER LINE OF VEHICLE.
4. Determine which programming you will be us-
ing. The switches for this model are preset for
DIRECTV
®
programming. To set the switches for
DISH Network
®
, or EXPRESSVU, see the illustra-
5. On each foot, screw the flange nut to the
base of the leveling screw on the mounting
foot, flange up. Place rubber washer, with the
rubber side up, on the nut, Figure 2. Push
mounting foot under base. Push foot screw
through the base and tighten lock nut to se-
cure foot to base. Be sure the base feet are
pointing away from the base. Base feet will be
removed later during install.
!
Installation
Install in DRY conditions only!
Installing unit on roof of vehicle —
Obstruction Ht. Unit Clearance
8” .......................................... 4”
10” ................................... 11.5”
12” ...................................... 19”
15” ...................................... 32”
FIGURE 2
LEVELING SCREW
RUBBER WASHER
FLANGE NUT
(FLANGE UP)
MOUNTING
FOOT
FIGURE 3
OBSTRUCTION
UNIT BASE
(FACTORY PRESET)
tion below.
(#1 represents Switch DOWN; #0 repre-
sents Switch UP)
1 2 3 4 5 6 7 8
0= UP
1= DOWN
1 2 3 4 5 6 7 8
0= UP
1= DOWN
1 2 3 4 5 6 7 8
0= UP
1= DOWN
