Assembly GUIDE
or visit
wineracksamerica.com
Questions?
888.373.6057
High Reveal Rack
Page 3
4. Secure the remaining standard connector so that the top of the connector is 6" from the bottom of the rack.
(figure 3)
Bottom of rack
3
ATTACH REMAINING
STANDARD CONNECTOR
5. Flip the rack over and attach a screwless connector to the top of the rack (figure 4). Attach the remaining screwless
connector so that the bottom of the connector aligns with the bottom of the middle ladder risers (figure 5). Secure
the bottom reveal connector to the two end ladders and center ladder at the bottom of the rack. (figure 6).
High Reveal Racks are designed to show no visible hardware on the front of the rack. Use one of these following
methods to install the screwless connectors:
6"
For no visible hardware, add wood glue to the inside of each connector notch. Place the connnector on your
rack and carefully press each notch into place. Hold until glue is dry. (figure A)
For minimal visible hardware, add wood glue to the inside of each connector notch. Place the connector
on your rack and carefully press each notch into place. Hold until glue is dry. For added support, use a finish
nailer to attach the connector to the two end ladders and one middle ladder. (figure B)
For a professional installation, secure the connectors using a finish nail gun to drive a nail through the connector
into each vertical ladder. If you do not have a finish nail gun, drive one of the provided finish nails into each
vertical ladder until it is flush. Then, countersink the nail using a nail setter until the head of the nail is about
1/16" below the surface of the wood. Use provided wood putty to fill nail holes. (figure C)
A
B
C
+
++
or
A
B
C
