15.)
Ventilate the room when cleaning has
been completed. Keep all traffic off the
carpet until it is thoroughly dry.
16.)
When done cleaning for the day bring
the machine to a utility sink and floor
drain. Perform the
maintenance. Set the recovery tank
aside
so
solution tank will dry.
When not using the machine put the
brush in the storage position.
(see daily maintenance on page 8)
Leaving the brush on the floor for
long periods of time may ruin it.
CAUTION:
To Use a n Accessorv
Tool;
.)
Turn the machine completely
off and
unplug
it
from electrical outlet.
2.)
Connect the solution hose to the brass
fitting on lower left side of machine.
3.) Connect the
hose to the left side
of
the dome (side with white hose cuff).
4.)
Fill the solution tank.
5.) Plug the machine in and turn on only
the
switch.
CAUTION
:
Using accessory tool with brush
switch on may damage floor.
6.)
Turn
off the machine and unplug it
from electrical outlet before
disconnecting accessory tool.
Accessorv
Tools;
Standard Floor Wands
(SFW, SW, or
SW-PRO)
Deluxe Hand Tool (DHT)
Upholstery Hand Tool
SPIRIT
t
Determine precisely what areas you are go-
ing to clean. Note problem areas in the car-
pet or tack strip.
Look for loose carpet,
heavily damaged areas, discolored stains,
or grease spots that will require prespotting.
Note the carpet type. Check the availability
of hot water, drains, and suitable electrical
outlets. If the carpet
is
loose or worn, have
it repaired
before
attempting to clean
it.
Route:
Work from the most remote area towards the
exit.
Try not to travel over the cleaned areas
when getting fresh water or dumping old.
Furniture should be moved away from the
walls before cleaning. If furniture is moved
back in place before carpet is completely dry,
place plastic or foil protectors under the legs
to prevent possible carpet staining. When
possible use a Windblower
and open
all windows and doors to speed carpet dry-
ing.
neral
Information;
Vacuum carpet
Always take the time
to thoroughly vacuum carpet before using
the extractor.
On heavily soiled carpets, or on areas of
high foot traffic,
it
may be necessary to use
a
prespray or traffic lane cleaner applied with
a separate sprayer.
Do
not add presprays to
the machine's solution tank.
If
a spotter is
used, follow the manufacturer's instructions
exactly as printed on the label.
Use an accessory tool to remove spotter.
Spotter left in the carpet may bleach or
brown it permanently.
Shag or deep pile carpets
may require sev-
eral passes from different directions, but the
operator must be careful not to over saturate
the carpet. Make several passes without
spray to extract as much moisture as pos-
sible.
Rinse carpet after cleaning
so that sticky
soap build-up will not cause carpet to quickly
become soiled again.
Go back over carpet
using only clean warm water in solution tank.
7
