30
Maintenance
Disconnect batteries before working on machine. Only
qualified personnel should work inside machine.
Always wear eye protection and protective clothing
when working on or near batteries. Avoid skin contact
with the acid contained in the batteries.
Vacuum Motor Carbon Brush Replacement
1. Remove rear cover from machine.
2. Remove batteries from machine.
3. Remove 4 bolts holding access cover in place and
remove cover.
4. Pull top clips from vacuum motor top brush
retainers.
5. Remove and inspect brushes.
6. Replace both if either is less than 3/8" (9.5
mm)long.
7. Reverse steps to assemble.
To Remove Vacuum Motor
1. Remove rear cover.
2. Remove two screws from top of control panel and
four screws from side of control panel housing.
3. Slide control housing back from tank to expose
main cover bolts.
4. Remove four bolts in front of console from cover,
and 2 bolts from the bottom front of main cover,
and two inside, next to batteries.
5. Remove main cover.
6. Remove four bolts from vacuum motor and discon-
nect plug.
7. Reverse steps to assemble
86037810 Chariot iVacuum
