STEP 1:
Plug the control panel cable into the motor base. (Arrow
direction as figure)
STEP 2:
Assemble the receiver onto the motor base. Then turn screw A
clockwise tightly.
STEP 3:
Mount the rear guard to the motor housing by matching the 4
holes in back to the 4 slots on the front cover. Then install 4 screws to
lock the rear guard and the front cover.
STEP 4
: Insert the blade onto the motor shaft by matching the slots of
the blade with the pins in the shaft. Tighten the blade with the blade
cap by turning it counter-clockwise. Loosen and remove the screw from
the front guard. Then assemble the front guard with the rear guard.
Resecure the screw.
PARTS
ASSEMBLY
Mounting Bracket
Motor Base
Setting Screw
Rotator Arm
Motor Housing
Cover
Power Cord
Rock Frame
Guard Ring
Blade
Blade Cap
Guard Mark
Control Panel
Guard Lock
Ring
Remote Control
Front/Rear Guard
STEP 1
STEP 2
STEP 3
