Page 1 of 6 Instal Instr Electric Cooktop CTE P Rev B.doc
351 Thor Place
Brea, Ca 92821
(714) 482-2320
Fax (714) 482-2337
INSTALLATION INSTRUCTIONS
ELECTRIC COOKTOP MODELS: CTE36P, CTE48P
IMPORTANT:
Save these instructions
for Local Electrical Inspector’s use.
INSTALLER:
Please leave these Installation Instructions with this unit for the owner.
OWNER:
Please retain these instructions for future reference.
READ AND SAVE THESE INSTRUCTIONS
Before beginning, please read these instruction completely and carefully
.
IMPORTANT SAFETY INSTRUCTIONS
WARNING
–
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO
PERSONS, OBSERVE THE FOLLOWING:
1.
Use This Unit Only In The Manner Intended By The Manufacturer. If You Have Any Questions, Contact
The Manufacturer.
2.
Before Installing Or Servicing Unit, Switch Power Off At Service Panel And Lock Service Disconnecting
Means To Prevent Power From Being Switched On Accidentally. When The Service Disconnecting Means
Cannot Be Locked, Securely Fasten a Prominent Warning Device, Such As A Tag, To The Service Panel.
POWER SUPPLY
–
Power supply is dual rated: 240 VAC or 208 VAC, 3-wire, 60 Hz, 50Amp circuit breaker
required for all models.
JUNCTION BOX
–
Plan the installation of the unit so that the location of the junction box is within three (3)
feet of the right-rear bottom corner of the cooktop. The junction box must be accessible
from the front of the unit. See FIG
–
5.
CABNET PREPARATION AND CLEARANCE
–
Be sure your appliance is properly installed and
grounded by a qualified technician.
To eliminate the risk of burns or fire by reaching over heated surface units, cabinet storage space located above
the surface units should be avoided. If cabinet storage is to be provided, the risk can be reduced by installing a
range hood that projects horizontally a minimum of 5 inches beyond the bottom of the cabinets.
