Wincomm WTP-9E66-15, Руководство пользователя

Страница: 27 / 68

21
On an edge detect from 0 to 1, the PCH starts a COMRESET initialization
sequence to the device.
SATA Device Type
Identify the SATA port is connected to Solid State Drive or Hard Disk Drive.
Topology
Identify the SATA Topology if it is Default or ISATA or Flex or DirectConnect or
M2
Device Sleep
mSATA for RTD3.
SATA DEVSLEP Idle Timeout config
Enable/Disable SATA DTIO Config
Info Report Configuration
Post Report
Post Repost Support Enabled / Disabled.
Info Error Message
Info Error Message Support Enabled / Disabled.
Summary Screen
Summary Screen Support Enabled / Disabled.
USB Configuration
USB Support
USB Support Parameters.
Legacy USB Support
Enables Legacy USB support. AUTO option disables legacy support if no USB
devices are connected. DISABLE option will keep USB devices available only for
EFI applications
XHCI Hand-off
Enable / Disable XHCI Controller Legacy support.
USB Mass Storage Driver Support
Enable/Disable USB Mass Storage Driver Support.
USB hardware delays and time-outs:
USB Transfer Time-out
The Time-out value for control, Bulk, and Interrupt transfers.
Device reset time-out
USB mass storage device Start Unit command time-out
Device power-up delay
Maximun time the device will take before it properly reports itself to the Host
Controller. 'Auto' uses default value: for a Root port the delay is taken from
Hub descriptor.