WMP-226(V)/227(V) User’s manual
22
This is typically required when the user wants to examine the
physical parameters of the host adapters transmit PHY (eg
examine the ‘eye’ on a scope or similar).
IDE Legacy / Native Mode Selection.
IDE Legacy / Native Mode Selection.
Info Report Configuration
System configration information report. It includes Post
report/Error message report/Summary report
USB Configuration
Legacy USB Support
Enables Legacy USB support. AUTO option disables legacy
support if no USB devices are connected. DISABLE option will
keep USB devices available only for EFI applications
EHCI Hand-off
This is a workaround for 0Ses without EHCI hand-off
support. The EHCI ownership change should be claimed by
EHCI driver.
USB Mass Storage Driver Support
Enable/Disable USB Mass Storage Driver Support.
USB transfer time-out
The time-out value for Control, Bulk, and Interrupt transfers.
Device reset time-out
USB mass storage device Start Unit command time-out.
Device power-up delay
Maximum time the device will take before it properly reports
itself to the HOST Controller.
‘Auto’ uses default value: for a Root port it is 100 ms, for a
Hub port the delay is taken from Hub descriptor.
Serial Port 1~4 Configuration
Serial Port 1 Configuration
Set Parameters of Serial Port 1.
Serial Port 2 Configuration
Set Parameters of Serial Port 2.
Serial Port 3 Configuration
Set Parameters of Serial Port 3.
Serial Port 4 Configuration
Set Parameters of Serial Port 4.
Serial Port 5~6 Configuration(Optional)
