7
REV C
60706-241
7. Assemble cable clamp over the outer jacket of the wire and
tighten the two clamp screws. Special Note: For small size round
(less than 3/4”) and flat cables, the wire clamp may be inverted.
Page 4
60706-180
0310-00
ELECTRICAL CONNECTIONS
CAUTION:
Only qualified electricians should install electrical wiring.
Wiring must conform to all applicable national, state, and
local codes. (Reference: National Fire Protection Associa-
tion Manual No. 70, National Electrical Code.)
DANGER: P
ERSONAL INJURY
IF THE GENERATOR IS TO BE USED AS A STANDBY
POWER SOURCE, A MANUAL TRANSFER SWITCH
MUST BE INSTALLED TO SEPARATE THE GENERATOR
AND THE COMMERCIAL POWER LINES. THE SWITCH
MUST ISOLATE THE GENERATOR FROM THE COM-
MERCIAL POWER LINES AND THE LOAD WHEN THE
GENERATOR IS ON STANDBY, AND MUST ISOLATE
THE COMMERCIAL POWER LINES FROM THE LOAD
AND THE GENERATOR WHEN THE GENERATOR IS
SUPPLYING POWER. SEE FIGURE 6
Figure
Typical Connection Methods for Generator Power Service
WARNING: PERSONAL INJURY:
Failure to wire as instructed may cause personal injury or damage to
device or equipment. To be installed or checked by an electrician or
qualified person only.
