Winco Spectrum ECT-700, Инструкция по установке и эксплуатации

Страница: 7 / 12

7
If your SPECTRUM™ Commercial Conveyor Toaster does not operate, please check the following before placing a service call:
Troubleshooting
Service and Repair
THIS EQUIPMENT MUST ONLY BE SERVICED BY AN AUTHORIZED AGENT.
NOTE
Parts protected by the manufacturer or its agent are not to be adjusted by the installer unless the installer is an authorized service agent.
If you have any questions or problems DO NOT send unit to WINCO® without first contacting our customer service department.
See "Limited Warranty" section on page 11 for details.
ISSUE MIGHT BE CAUSED BY RECOMMENDED SOLUTION
The unit is not working;
POWER indicator light is not on
Main power supply Check main power supply
Unit is not switched on
Check that the unit is correctly plugged in and turned on; ensure that
you've read & understand the manual for correct operation
Faulty dial control Check that set screws on both knobs are correctly secured
Plug and lead are damaged
Unplug the unit from power source and inspect cable for fraying or
damage.
Internal wiring fault
Call WINCO to make service arrangements through its Service
Provider Network
The unit is heating up but POWER
indicator light is not on
Power indicator light is faulty Replace Power indicator light
Slow heat up or no heat up, but
Power is ON
Incorrect operation
Ensure that you have clearly read the manual, to understand the
operating functions
Warm up Allow five (5) minutes for unit to warm up
Elements are faulty
Replace faulty elements - Replacement must be done by an
authorized service provider
Faulty power selector switch
Replace faulty power selector switch - Replacement must be done
by an authorized service provider
Incorrect voltage
Make sure power is connected to correct voltage for this unit - see
name-plate on back of unit for correct voltage
The carry chain does not work
Unit is not on, or the power selector
switch is not activated
Turn the unit on and adjust function control to required setting
Faulty speed control
Replace faulty speed control - Replacement must be done by an
authorized service provider
Motor fault Check input power
Gear / Chain fault Inspect drive chain for any broken links
Incorrect voltage
Make sure power is connected to correct voltage for this unit - see
name-plate on back of unit for correct voltage