6
OPM-148
REV A
PREPARING THE UNIT
START-UP CHECK LIST
A Start-Up Completion & Warranty Validation Form was
sent along with this manual. This must be completed and
returned to WINCO Inc. within 180 days of the factory
invoice date.
If this form is not returned, the Warranty may be voided.
UNPACKING
1. As you receive your unit, it is critical to check it for any
damage and annotate it on the BOL. If damage is noted,
contact WINCO for assistance in getting the generator
repaired.
2. Before proceeding with the preparations of your new
generator for operation, take a couple of minutes to ensure
the unit you have received is the correct model and review
the specification pages in this manual to ensure that this
unit meets your job requirements.
CAUTION: EQUIPMENT DAMAGE
This unit is shipped with oil and a 50/50 mix of
coolant. Be sure to check all fluid levels before
operating. See engine manufacturer’s instruction
manual for recommended oil requirements before
initial starting.
Once generator set is on-site:
After inspecting the engine-generator for external, physical
damage, locate and check the following items packed with
the unit:
a. Installation and Operator’s Manual.
b. Engine manufacturer’s instruction manual.
c. Battery hold-down brackets & hardware.
d. Unit components or accessory items shipped loose
for
on-site
installation.
e. Optional accessories.
LIFTING THE GENERATOR SET
1. Make sure that the area under the equipment is kept
clear.
2. Be certain rigging is designed to lift unit safely.
3. Never attempt to lift the unit unless you are certain the
lifting device has sufficient capacity.
4. Never allow the unit to swing while suspended.
5. Be certain the supporting structure is adequate to
handle the weight of the unit.
CAUTION
Only lift the unit using the factory installed lifting eye,
located on top of the unit’s housing.
TOWING THE EQUIPMENT
CAUTION
Only transport by a towing vehicle with adequate
GVWR rating.
WARNING: EQUIPMENT DAMAGE
Never operate generator set during transportation.
1. Always use a vehicle capable for safe operation.
2. Never tow without the safety chains secured.
Always inspect safety chains, replace if damaged.
3. Always use the proper ball hitch size on the vehicle.
4. Never attempt to tow with a vehicle without side
mirrors
installed.
5. Verify all trailer lights function as intended.
6. Verify all lug nuts on the trailer are secured. Repeat this
process after traveling 50 miles.
BREAK-AWAY SYSTEM
A break-away system has been installed. Should the trailer
become disconnected while driving, the break-away system
will engage the electric breaks.
Always test the system before each outing by pushing the
TEST button. There are three readings:
Full
Low
Charge
SETTING THE JACKS
WARNING
Ensure the generator is properly secured on level
ground. Failure to do so could cause the generator to
suddenly roll away or move.
1. Rotate the front jack from transport position to run
position.
2. Level the unit using the jack before starting the unit.
4. Return jack to transport position before moving the
unit.
