7
Safety
SAFETY PRECAUTIONS
Before installing and operating this equipment be
sure everyone involved in its operation are fully
trained and aware of all precautions. Accidents
and problems can result from a failure to follow
fundamental rules and precautions.
•
A WINCO® Approved Recommended Qualified Service Technician
should carry out repairs if necessary. Do not remove any
components or service panels on this product.
•
Allow the unit to cool down after use before dismantling for
cleaning;
the unit will be too hot to handle immediately
after use.
•
Before cleaning, switch power OFF and disconnect power cord
from the outlet.
•
Do not immerse unit in water or use hose to clean.
Ne jamais immerger l'appareil dans l'eau ni utilisez un jet
d'eau pour le nettoyer.
•
If the power cord is damaged, it must be replaced by a WINCO®
Approved Recommended Qualified Service Technician in order to
avoid a hazard.
4. Remove the set screw underneath the floss spinner. Slowly lift
off the floss spinner until it is off the shaft. Once it is off, carefully
remove the power wires.
5. Remove the screws holding the carbon brushes and gently move to
the side to expose the belt.
6. Loosen the screws holding the belt. The belt will slide towards
the center of the unit.
7. Remove the old belt and place in new belt.
8. Reassemble the unit by reversing previous steps.
