Page 2 of 3
006115
Revision Q Date 01-28-11
JWC
4. Repeat procedure on opposite side until both
Snap Buttons
are snapped into corresponding holes of
Back
Frame
.
NOTE: Snap buttons must protrude out of holes on back frame.
Install Lateral Supports (LS option only)
5. If your chair has
Optional Lateral Supports (LS)
read steps 6 thru 9, otherwise skip to item 10.
6. Use
Phillips
screwdriver to loosen the upper
Back Frame screw
(do not remove).
7. Position the T-slot on
Lateral Support Bracket
around the screw between
Back Frame
and
Upholstered
Back.
8. Be sure that screw is seated completely in T-slot and Lateral Support drops down into T.
9. Re-tighten the upper
Back Frame screw
.
Operation of the Tray:
10.
Tray Arms
are inserted into the
Tray Receiving Tubes
(under Armrests on chair). The
Tray
automatically
locks into the first position, depress the
Snap Button
(on Right Tray Arm) for 2 more positions.
NOTE: Left and right is based as if you are seated in chair.
11. The
Right Tray Arm
is movable to compensate for minor variations in the width of the chair.
12. Storing the
Tray;
Insert the left tray arm tube into the right tray receiving tube and the
Snap Button
will lock it
into place. Allow the right side of the table to hang down vertically on the right side of chair (Left & Right; as if
you are seated in chair).
Operation of the Chair:
13. NON-RESTRAINT: To make the chair permanently non-restraint, remove the
Snap Button
of the
Right Tray
Arm,
and unbolt the
Position Lock Bar
from the back of the chair.
14. POSITION LOCK: Attendant may hold the chair in a reclined position by engaging the Position Lock. To
safely accomplish this, recline the chair to the 2
nd
or 3
rd
recline position and lower the position lock with your
hand until the notches on the Position Lock bars engage with the Position Lock Pins.
To release Position Lock, raise the Position Lock off of the Pins and return chair to upright position.
15. To ensure proper operation of the reclining mechanism, lubricate all pivot points with a silicone lubricant at
least twice yearly.
Wrinkles in Vinyl –
Storage and shipping can cause wrinkles of the vinyl on your Winco chair. This is normal.
Please allow 1-2 weeks at room temperature (approx. 70 degrees) to allow for vinyl to expand back to original
appearance.
WARNING: Failure to lock back and seat frames together may cause injury.
WARNING: Attendant must release Position Lock before patient can exit chair – If patient attempts to
exit chair with Position Lock engaged, SERIOUS INJURY MAY RESULT.
WARNING: Failure to release the Position Lock before changing positions will result in damage to the
chair and void the warranty.
Periodically recheck tightness of all screws and bolts, and never use the chair arms, backrest, legrest or
tray as a seat or the tray as a restraint.
