Winbest Pro-200, Руководство пользователя

Страница: 3 / 6

4 5
Assembly
Assembling the detector is easy and requires no special tools. Just follow these
steps.
1. Loosen the Top stem’s (1) lock nut in the direction of the
arrow. Then insert the lower stem (2) into the top stem
connected with the handle. Turn the stem’s lock nut in the
reverse direction of the arrow to lock it in place.
2. Unscrew the bolt of the control box (3) and hitch the
control box to the top stem. Then, insert the bolt into the
assembly hole on top stem and tighten it with the box. (4)
Top Stem
Arm Support
Locknut
Control Box
Connector
and Knob
Headphone
Jack
Battery
Compartment
Search Coil
3. Wind the cable around the stem. Insert the search coil cable plug into the five
pin jack at the bottom of control box’s housing (5).
4. When you stand upright with the detector in your hand, the search coil is level with
and about .5~2 inches / 1~5cm above the ground. You can lengthen or shorten
the stem basing on your height. After figuring out the suitable length, then tighten
the lock nut.
Caution:
• The search coil cable plug fits into the connector only one way.
DO NOT force the plug or you could damage it.
• DO NOT disassemble the stem lock nut.
In case you disassemble it, please refer to following remark to reassemble it.
Search Coil
Loosen the knobs at the search coil’s end; adjust the search coil to the desired angle.
(The search coil should be parallel with the ground.) Tighten the knobs just enough
to keep the search coil from rotating or wobbling.
INSTALLING BATTERY
You need one 9V alkaline battery to power your detector.
1. If the detector is on, turn the power switch (on the control panel) to POWER OFF.
2. Press on the battery compartment cover and slide the cover off in the direction of
the arrow.
3. Connect the battery with the battery connector taking care of the polarity. Then put
the battery into the compartment.
4. Replace the cover.
Lower
Stem
1 2
3
3 4
5
Preparation
Parts of the Metal Detector
Cable Plug In