WiMo W2IHY, Руководство по эксплуатации

Страница: 4 / 14

TABLE OF CONTENTS
-4-
Rear panel Controls ...........12
- Mic Output B
- Phones
- Power
Bottom Panel Controls ... 13
- Pictorial
- Mic In Gain
- Mic Output Level
- Mic input impedance
Schematics
- 8 band Mother Board...14, 15
- 8 Band EQ Pot Board … 16
Getting Started Tutorial.. 18,19
- Adjusting Mic In Level
- Adjusting Mic Out Level
- Adjusting Noise Gate Level
- Adjusting Noise Gate Delay
- Adjusting the Equalizer
Changing EQ Bandpass
Center Frequencies ........17
-25-
MIC OUT WIRING OPTIONS
MIC OUT A/B
5 Pin Male DIN
Din connectors shown
on side to be soldered
Gnd
PTT
- Mic
+ Mic
Balanced
Output
Hi-Z Output
Low Impedance Balanced Output to Low Impedance Radio
5 PIN DIN MIC OUTPUT CONNECTION
Low Impedance Unbalanced Output to Low Impedance Radio
Low Impedance Unbalanced Output to High Impedance Radio
High Impedance Unbalanced Output to High Impedance Radio
DO NOT CONNECT MIC WIRE SHIELD TO SHIELD OF DIN CONNECTOR
CONNECT ONLY AS SHOWN
MIC OUT A/B
5 Pin Male DIN
Din connectors shown
on side to be soldered
Gnd (Mic cable shield)
PTT
- Mic
+ Mic
Balanced
Output
MIC OUT A/B
5 Pin Male DIN
Din connectors shown
on side to be soldered
Gnd (Mic cable shield)
PTT
+ Mic
Unbalanced
Output
MIC OUT A/B
5 Pin Male DIN
1K Ohm
Din connectors shown
on side to be soldered
Gnd (Mic cable shield)
PTT
+ Mic
MIC OUT A/B
5 Pin Male DIN
1K Ohm
Din connectors shown
on side to be soldered
Gnd (Mic cable shield)
PTT
HI-Z