WiMo EAntenna 144XLFA16, Руководство пользователя

Страница: 11 / 18

Step 1
Step 2
Step 3
M6 Ring x 50mm
SA048-9660
Wire Clamp
Boom
Boom
Guy joint in the Boom
Once done Step 1, insert the ring by screwing on the 2 threaded studs that
are in the boom to reach the top of the upper nut. Place the other washer
and nut with your fingers to get the most you can with your hand. After a key
10, the first torque nut is nearer to the pin and then the bottom.
When it is finished, we continue to Step 3.
Pass the end of the rope Mastrant P5 once or twice through the hole in the
ring and attach the cable clamp firmly with maximum pressure.
Once it is fixed, you go to Step 4 which is to place the
EA010007D plate ,
where the tension of the string are fixed.
To put the Tightener (P1500003) before you have to have fixed plate (EA010007D)
with the U-bolt (A-0163) and tube Clamp (23035.50).
Once firmly attached, insert the Tightener into the hole and thread the rope through the
ring Mastrant P5 tensioner and tightening firmly tighten the cable clamp to secure the
rope.
Note that to tighten the rope previously have to open all the threads of the
turnbuckles.
Step 4
For increased wind resistance, this antenna includes an anchor system for
better conservation before the Climatological.
The plate
(EA010007) , must be at least 50cm apart on the plate that holds the
boom, so you can have enough angle to make the tension force the ropes, so
this system function can be applied.
The first step is to place the boom in the ring M6x50mm with nut on each side of
the screw tightening torque to each side of the boom (Step 1)