Wilton 8014FW, Инструкция по эксплуатации и каталог запасных частей

Страница: 22 / 56

22
Maintenance
Before doing maintenance on
the machine, disconnect it from the electrical
supply by pulling out the plug or switching
off the main switch! Failure to comply may
cause serious injury.
Use a brush to loosen accumulated chips and
debris. Use a shop vacuum to remove the
debris.
Make sure the chip brush on the lower band
wheel is properly adjusted.
If the power cord is worn, cut, or damaged in
any way, have it replaced immediately.
The chart (Figure 28) identifies areas that
require cleaning and/or lubricating. Use good
quality, general purpose lubricants.
Machine Part Lubricant Frequency
Bearings Machine oil Wipe down every day and
lubricate every 6 months
Rack and sliding portion of
Guide Post Grease weekly
Worm gear Grease every 3 months
Gear Box (8020FW only) Grease as needed
Variator pulley – use fitting at
end of shaft (C, Figure 13) Grease every 100 hours
Blade tension screw Grease once a month
Air compressor reservoir (see
D, Figure 13) Air Tool oil every 6 months
Weld clamp jaws ------- clean after each use
Rubber tire ------- wipe off daily
Work table ------- clean daily
Figure 28