•
To remove the inner part, turn its connector in the direction of the arrow marked "LOOSE" and
then pull the connector out of the inlet.
•
The hoover also offers the possibility to connect a hose to the outlet so that it can also be
used as a blower. The hose is connected to the connector by pressing the socket (IX).
Commissioning
Attention
!
Sucking up hot ash is prohibited. The temperature of the suction material must not exceed
40
.
℃
•
Make sure that all preparatory activities have been carried out.
•
Likewise, make sure that the hoover switch is set to "O" (Off) (V).
•
Now insert the plug of the power cord into the mains socket, then set the switch to "I" (On).
•
After finishing work and before maintenance work, switch the hoover off again at the switch
and pull out the plug.
Notice!
When using the hoover as a blower, make sure that the container has been emptied and the
filter cleaned or replaced with a new one. There is a risk of debris still remaining in the container being
blown out through the outlet opening.
Maintenance
Note!
Pull out the plug before maintenance work!
•
After each use of the hoover, the container, the lid seal and the air filter must be checked as
described in these instructions.
•
The ash vacuum cleaner is cleaned from the outside with compressed air of no more than 3
bar pressure. Special attention should be paid to the permeability of the ventilation open-
ings of both the supply and exhaust air. If necessary, clean them with compressed air of no
more than 3 bar. Do not use sharp metal objects to clean the ventilation openings.
•
Do not immerse the ash vacuum cleaner in water for cleaning.
•
The hoover hose must be checked for damage before and after use. It is forbidden to use a
damaged hose. Major soiling of the housing should be removed with a soft cloth.
https://www.XPOtool.com
Artikel 63122
Seite 7
The Tool Experts
04 2021-1
