© by WilTec Wildanger Technik GmbH
Seite 3
http://www.wiltec.info
Kleinteile (je Beutel):
1.
(4x) M4x12 screw
(4x) M4x30 screw
(4x) M4 toothed washer
4.
(4x) M8x16 screw
(4x) M84x0 screw
(4x) M8 toothed washer
2.
(4x) M5x12 screw
(4x) M5x30 screw
(4x) M5 toothed washer
5.
(4x) M4/M5 Spacer
(4x) M6/M8 Spacer
(4x) M4/M5 Washer
3.
(4x) M6x12 screw
(4x) M6x35 screw
(4x) M6 toothed washer
6.
(1x) Bubble Level
(6x) M86x0 Hex lag bolt
(6x) Washer
(6x) Concrete rawl plugl
Necessary tools:
Crosstip screwdriver
Metal detector for drywall-mounting
Screw wrench
Drill machine with 10 mm masonry drill
Note:
For the mounting of the wall plate introduce the level in
the tube and after the installing take it out.
Installing on a drywall construction
For a safe drywall mounting please use two wooden
beams/rails placed at least at a 30 cm distance from
each other.
1. Use a metal detector to find two adjoining rails and mark
their position.
2. Place the wall plate on the desired place with the help of
a second person and the level.
3. Mark right and left the upper, middle and lower oblong
holes, that are above the beams or rails.
4. All in all 4 or 6 places have to be marked.
5. First pre-drill a 3 mm hole in the wall.
6. Assisted by a second person, position the wall plate on the wall and place the oblong holes over
the drilled holes so that they match.
7. In each hole insert a hex lag bolt with washer.
8. Tighten the hex lag bolts clockwisely.
Beware:
Do not fasten the bolts too tightly in order to avoid causing damage to the wall.
Beware:
Do not let go of the wall plate, before it is properly fixed.
Installation on a concrete wall
Attention: concrete rawl wall plugs or special rawl plugs must be used from the local ironware
trades.
1. First place the wall plate on the wall with the help of the bubble level.
2. Mark right and left the upper, middle and lower oblong holes.
3. First drill bores with a 10 mm
– masonry drill.
4. Insert in every hole a concrete rawl plug and if necessary hammer it carefully in the borehole.
5. When the rawl plugs are inserted, place the wall plate over them so that the position of the
rawl plugs coincides with that of the oblong holes.
6. Screw the hex lag bolts in the rawl plugs, tighten them lightly and screw tightly only after all
hex lag bolts have been already inserted.
