© by WilTec Wildanger Technik GmbH
Item 63132
Page 7
03 2022
-1
•
Fire and explosion hazard!
Carry out the leakage test very carefully Overlooked leakages
can lead to fires that are no longer controllable while the gas cooker is in operation.
Serious property damage and serious injuries can result.
1.
Prepare a light soapy solution (soap and lukewarm water).
2.
Make all connections properly.
3.
Open the gas cylinder valve (anti-clockwise rotation). In case you can now hear a whistling
sound, immediately close the valve again, as there is most likely damage to the connections.
When indicated, notify the fire brigade and a gas system technician.
4.
Check every point of the entire gas piping system from the cylinder to the burners by applying
a small quantity of soapy solution.
5.
With bubbles forming, there is a leak. Close the gas cylinder valve (clockwise rotation) and
check if the leak can be repaired (e.g., a connection is not completely closed and only needs to
be tightened properly).
6.
Re-check the spot.
Installation and storage
The product must be set up so that
•
neither children nor pets can get into contact with it,
•
it is not in or directly next to corridors, paths, or other much-frequented areas,
•
it is not exposed to rough weather conditions (e.g., strong winds, snow),
•
there is no tripping or falling hazard next to it,
•
it is on a fireproof, flat, solid, stable, and anti-slip surface,
•
there are no constructions in the vicinity (around 3
m),
•
you can observe it during the entire operation.
The gas cooker may only be stored if it
•
has entirely cooled down and dried off (if necessary).
•
has been cleaned,
•
has been disconnected from the gas cylinder/can be stored separately.
CAUTION!
Note that storing the device in (totally) closed rooms or in outside areas is not permitted.
Operation
•
After connecting the gas cylinder, the amount of gas escaping and thus the output of the burner
can be controlled using the thumb wheel on the regulator (part D).
•
The gas needs to be ignited externally: Set a low gas flow and generate a spark just above the
burner outlet openings as quickly as possible; then set the required output.
•
The igniting spark may be generated by a lighter, match, or device generating sparks. In all
cases, ensure a sufficient distance to the burner, e.g., with long chimney matches or a stick
lighter.
•
The product is delivered ready-to-use; however, it may be advisable to take basic measures to
prevent rust. Clean the product with a damp cloth (not under running water!), dry it well, and
apply a thin layer of cooking oil to the surface (preferably with some kitchen paper) without
getting the oil into the outlet openings.
Food safety
•
Do not thaw meat/fish at room temperature or in the microwave, but in the refrigerator overnight.
•
The food must not stand in the defrosting water – you can wrap it with kitchen paper.
•
Always wash your hands, used dishes/tools, and the work area with soap and hot water after
contact with raw meat/fish.
