Sprayer assembly
Assemble the sprayer by connecting the jet pipe and the spray gun.
Once connected, turn the jet pipe in order to lock it in place.
Attention:
Before connecting the
sprayer to the pressure cleaner, make sure that the jet pipe is firmly and correctly attached to
the spray gun.
Place the nozzle on the free end of the jet pipe.
Attention:
When attaching the nozzle, the
lock indicator button (A) located on the nozzle should pop out. Before connecting the sprayer
to the pressure washer, check the nozzle in order to ensure that it has been connected cor-
rectly.
Water supply
Follow the instructions of your water supplier. Information concerning the supply line can be found on
the nameplate/in the technical specifications. Always use an enhanced hose (not included in the scope
of delivery) with a standard connection (outer diameter: 16 mm, inner diameter: 12 mm) and a max-
imum length of 25 m.
Important!
Only use clean water without pollutants. If the water is for example obtained from a well,
an additional filter has to be used in order to prevent sand particles and other pollutants from dam-
aging the device. Let the water run through the hose before connecting the same to the device in order
to prevent sand and dirt from entering the device.
Note:
Always check if the filter has been placed within the water inlet of the device and make sure it is
not clogged. Connect the water hose to the water supply via coupling (max. pressure: 10 bar, max.
temperature: 60°C).
© by WilTec Wildanger Technik GmbH
Item 62571
Page 7
http://www.WilTec.de
http://www.aoyue.eu
11 2020
-1