Components
№ Name
1
Stirrer
2
Tool connecting shaft M14
3
Electronic speed regulator
4
2 step mechanical speed regulator
5
Locking device
6
Start button
7
Motor housing
Technical data
Nominal voltage
(V)
230
Nominal frequency
(Hz)
50
Nominal power
(W)
1600
Rotation speed
(
U
/
min
)
0–780
Mixing diameter
(mm)
140
Maintenance
Proper maintenance of the machine can extend its service life.
The handle switch must always function properly and be well maintained.
Avoid mechanical tension in the machine, as this will inevitably damage it.
The hexagon socket must always be provided with a protective cover.
The ventilation of the motor housing must not be covered while the machine is in operation;
there must be no inflammable materials in the machine.
The ventilation must be cleaned regularly.
Only identical original parts may be used on and in this machine.
Clean the mixer attachment after each use and before a long period of use. It is recommended
that only running water or quartz sand be used for cleaning.
The carbon brush must be checked and serviced after 60 hours of operation. Change the
brush in good time when you notice that it is worn out:
a) First disconnect the device from the power supply, remove the motor housing (see Fig. 1).
b) Pull out the plate and replace the carbon brush (see Fig. 2).
© by WilTec Wildanger Technik GmbH
Item 62354
Page 6
04 2021-1
