Operation
Preparation before washing
1. Place the drain hose to drainage so that the drained water can run off.
2. Plug the power supply cord to the mains but be sure to check first if the voltage corresponds
to the rating label of the appliance. You must use a European Two Round Pins Plug.
3. Insert the water inlet hose into water inlet connector.
4. Select the water level according to the quantity of laundry by referring to water level marking.
Washing procedure
Washing
Water Inlet: Put the water lever to the desired position.
Add water and dissolved detergent to make the water reach the ex-
pected level. Operate the machine to stir the detergent evenly by
turning the washing knob.
Put in laundry.
Select wash duration according to the weight of laundry.
Select washing type (Normal/Stronger) according to the weight of
laundry. After each end of a washing operation set the wash selector
to “Drain.”
Drain the water
Since the washing machine has a drain pump, the water will flow faster upon turning the
Drain Selector to drain position. Be sure to turn Drain Selector immediately back to normal
position when the water is completely gone from the wash tub.
Intermediate-spin (removing detergent/dry)
Move laundry from wash tub to spin tub.
Spin to remove dissolved detergent.
◦
Arrange laundry evenly in the spin tub without stacking them all on one side. An unbal-
anced spin tub may cause abnormal vibration and noise.
◦
Press the laundry down firmly and place the safety cap on top of it.
◦
After rinsing close the outer cover of the spin tub and spin for 1 minute.
© by WilTec Wildanger Technik GmbH
Item 62047
Page 5
http://www.WilTec.de
http://www.aoyue.eu
03 2021
-1