WilTec 61950, Руководство по эксплуатации

Страница: 14 / 19

© by WilTec Wildanger Technik GmbH Item 61950 Page 14
http://www.WilTec.de
http://www.aoyue.eu 05 2021 -1
http://www.teichtip.de
◦
The parallel stop can be mounted on either side of the saw table (1).
◦
The parallel stop has to be mounted in the guide rail (14) of the saw table (1).
◦
The parallel stop can be set to the required dimension with the help of the scale on the
guide rail.
◦
You can clamp the parallel stop in the required position by pressing the eccentric lever.
•
Setting the stop length
◦
The stop rail can be moved in the longitudinal direction in order to prevent the workpiece
from becoming jammed.
◦
Rule of thumb: The rear end of the stop comes up against an imaginary line that begins
roughly at the centre of the blade and runs at an angle of 45° to the rear.
◦
Set the required cutting width
– slacken the knurled screws, and push the stop rail forward
until it touches the imaginary 45° line.
– Re-tighten the knurled screws.
Cross stop
•
Slide the cross stop (21) into the groove of the table.
•
Slacken the knurled screw.
•
Turn the cross stop until the arrow points to the angle required.
•
Re-tighten the knurled screw.
•
Important! Do not push the stop rail too far toward the blade. The distance between the stop
rail and the blade should be approx. 2 cm.
Setting the angle
•
Undo the fixing handle.
•
Turn the handle to set the desired angle on the scale.
•
Lock the fixing handle again in the required angle position.
Overload protection switch
The motor of this appliance is protected against overload by an overload protection switch (11a). If the
rated current is exceeded, the overload switch switches the appliance off . After a short cooling-off time,
the appliance can be switched back on by pressing the overload protection switch.
Operation
Warning!
•
After every new adjustment, we recommend you to make a trial cut in order to check the new
settings.
•
After switching on the saw, wait for the blade to reach its maximum speed of rotation before
commencing with the cut.
•
Take extra care when starting the cut!
•
Never use the device without the suction function.
•
Regularly check and clean the suction channels.
•
The cap on the blade guard can be removed in order to be able to connect a suction hose to
the blade guard.
•
A suction adapter set for connecting a vacuum extraction system to the blade guard and to the
suction adapter is available as an accessory.
Longitudinal cuts (fig. 19)
•
Longitudinal cutting (also known as slitting) is when you use the saw to cut along the grain of
the wood. Press one edge of the workpiece against the parallel stop while the flat side lies on
the saw table. The guard hood must always be lowered over the workpiece.
•
When you make a longitudinal cut, never adopt a working position that is in line with the cutting
direction.