© by WilTec Wildanger Technik GmbH
Item 61059
Page 5
07 2021
-1
•
Thermostat settings:
After the heater has been turned on and the room temperature has become comfortable, slowly
turn the thermostat knob counter-clockwise until the heater shuts off (a faint clicking noise
should be heard). By setting and leaving the thermostat like this, the device will automatically
maintain the current temperature. By further turning it counter-clock
wise towards the “low” po-
sition, the temperature can be lowered. In order to raise the temperature, simply turn the knob
clockwise towards the “high” position.
•
Turning the device off:
Turn the switch to the “off” position before plugging or unplugging the heater. Always make sure
to unplug the device while it is not in use.
•
Fan mode:
Turn the power level control switch to the fan setting before turning the thermostat knob clock-
wise in order to make the fan run continuously.
Safety features
•
The power indicator lamp of the device will be illuminated if either the fan or the heater are
turned on.
•
The inbuilt overheating protection device will make sure to automatically turn off the device if
the heater grill is obstructed or the heater will grow too hot. Once the heater has been turned
off this way, it needs to be reset by turning it off and unplugging it. After waiting approximately
10 min in order for the device to cool down, the power cord can be reconnected and the heater
restarted.
•
This product is equipped with a tip-over-switch, too, which causes the heater to automatically
shut down if it tips over. Simply place the device on an even surface without obstructions and
make sure that it is in an upright position in order to restart the heating process.
Maintenance
•
Before cleaning the device make sure to unplug it and wait for the heater to cool down com-
pletely.
•
A washable filter is located at the air inlet and can be removed in case it should require cleaning.
In case this filter should appear to be dirty, simply remove it from the device after unplugging
the same and making sure that it had cooled down. The filter can be rinsed with warm water,
but needs to have dried completely before it can be reattached to the filter.
•
The outside of the heater can be cleaned with a damp piece of cloth while the device is un-
plugged.
•
Do not use any detergents for this process and never dunk the heater in water as it is not only
going to destroy the device, but can also be dangerous. Once the frame has been cleaned,
make sure to let the device dry properly before putting it to use again.
