© by WilTec Wildanger Technik GmbH
Item 61029
Page 8
10 2021
-1
12. Slowly lower the grinding wheel as shown in
fig. 10.
If you notice slight errors in your settings,
turn off the unit and unplug it before you make your adjustments.
Note:
A good grind can be achieved when the contact between the wheel and the teeth
are gradual and smooth. Do not process each tooth too long.
13. After sharpening one tooth, turn off the machine. Lift the
engine casing (12, 24),
release the
screw (52),
and move the chain to the next link, then position the
chain stop (53).
Tighten the
screw (52).
Turn the machine back on and continue sharpening the next tooth. Repeat this
process until you have sharpened all of the links set up for this angle.
14. After you finish sharpening all of the teeth on the chain, turn off the machine by pushing the red
button on the
switch (25)
and unplugging the unit.
15. Loosen the
lock wheel (46)
and reset the angle so that the first tooth that has not been sharp-
ened is positioned against the
screw (52)
and locked it as explained (see
fig. 11).
16. As you did with the first half of the chain, be sure to lower the
engine casing (12, 24)
so that
the
grinding wheel (5)
slightly touches the chain tooth, and lock it in place. Follow all of the
steps from 2 to 7 double checking everything before you plug in the machine and turn it on
again.
Attention:
Remember to turn the machine off and unplug it if you need to make any ad-
justments!
17. After you have repeated all of the steps regarding the sharpening, your chain is ready to be
mounted onto the saw.
Maintenance
•
Keep the sharpener clean and free of dust, metal debris and dirt.
•
Check the grinding wheel before each use to make sure it is not damaged. Do not use a grinding
wheel if it is chipped, cracked, or worn. You can check if the wheel has non-visible cracks to the
human eye by hanging it up by its central hole and tapping it with a non-metallic object (i.e.,
screwdriver handle). If it is in good condition, it will produce a metallic sound. A dull sound
indicates a crack or break.
•
Replace the grinding wheel after it has reached a diameter of 3
″
.
Please read the following carefully:
The manufacture and/or distributor has provided the parts diagram in this manual as a reference tool
only. Neither the manufacturer nor the distributor makes any representation or warranty of any kind to
the buyer that he or she is qualified to make any repairs to the product or that he or she is qualified to
replace any parts of the product. In fact, the manufacturer and/or distributor expressly states that all
repairs and parts replacements should be undertaken by certified and licensed technicians and not by
the buyer. The buyer assumes all risk and liability arising out of his or her repairs to the original product
or replacement parts there to or arising out of his or her installation of replacement parts thereto.
Note:
Some parts are listed and shown for illustration purposes only and are not available individually
as replacement parts.
