Evacuating toilets
1. Connect the horizontal toilet bowl outlet with the pump system rubber cuff and stretch the con-
nection with the enclosed clamp. Take care that you use a lubricant, if necessary, so that the
rubber connection does not tear.
2. Join the drain pipe with the rubber connection piece, the pipe should have a diameter of 40 or
32 mm. Seal the connection with the clamping piece.
Check the installation of the check valve
If the sewage water should be transported/pumped upwards, install the check valve as close as
possible to the macerator.
Evacuating toilets and other sanitary units
Connect the discharge pipes of the other appliances to the rubber connectors provided and clamp with
the pipe. For bath or shower waste water, check that the slope from the siphon has a gradient of at
least 1 cm per meter so that the waste flows towards the macerator by gravity.
If other appliances are connected along the discharge line near to the macerator, install check valves
on their discharge pipes in order to prevent waste return. The slope of the horizontal parts of the dis-
charge line must have a gradient of 1 cm per meter.
© by WilTec Wildanger Technik GmbH
Item 50741
Page 7
http://www.WilTec.de
http://www.aoyue.eu
11 2020
-1
