© by WilTec Wildanger Technik GmbH
Seite 9
http://www.wiltec.info
Concrete/Brick Installation
Note: 1/4”(8mm) anchor must be used for concrete installation. They can
be purchased at your local hardware store.
1. Place the wall plate against the wall with the hook towards the bottom.
2 .Level and mark with a pencil the two mounting points found on the wall
plate.
3. Next, drill two holes using an electric drill an
d 1/4” masonry bit
4. Insert the threshold anchors into the holes that were drilled in the wall.
Note: If necessary, use a hammer to lightly tap each anchor into place so
that they are flush with the wall.
5. Once the anchors are in place, put the wall piece back over the concrete
anchors.
6. Using a screw driver, attach the back plate by threading the two screws into
the anchor which has been recessed into the wall.
7. Make sure all screws are snug, but be careful not to over-tighten them.
Step 2
– Attaching the Arm to the LCD
1. Determine the mounting hardware that is to be used.
2 If your LCD has a flat back, use the M4x12mm Philips Head Screws (B).
Note: If your LCD has a recessed back, use the longer M4x30mm Phillips
Head Screws (C) and 3/4” spacers (D).
3. After you have determined the appropriate screws, use them to attach the
mounting plate to the back of your LCD
4. Do not over-tighten the screws.