© by WilTec Wildanger Technik GmbH
Item 34209
Page 5
02 2022
-1
User notes
•
The compressor has a 9.51
mm (⅛″) outlet with external thread which can be effortlessly
changed to ¼″. The matching adapter is not included in the delivery.
•
When the compressor is connected by the hose to the airbrush gun, it can be connected to the
mains and switched on.
•
The maximum pressure is displayed the pressure gauge, the operating pressure can be ad-
justed by the pressure regulator.
•
The hose included in the delivery is air-tight. If the auto-stop mode is activated (repeatedly
switched on/off) all screw fittings and connections should be sealed by sealing tape.
Leakage check
•
Switch on the compressor and wait until the maximum pressure has built up and the auto-stop
function has been activated.
•
If there is no leakage, the pressure gauge should display nearly constantly the same range of
pressure.
•
A quick decrease of the range of pressure suggests that there is in fact a leakage.
•
It is of great importance to seal any leak as soon as possible to avoid any impact on the capacity
and efficiency of the compressor.
•
A leakage leads to the auto-stop and auto-start constantly being switched on and off.
Difference between maximum pressure and operating pressure
•
The maximum pressure is the highest possible pressure that a compressor can generate.
•
The maximum pressure is the pressure measured only inside the compressor itself.
•
Once the maximum pressure has been reached, the compressor switches off (auto-stop), and
as soon as the pressure starts to decrease, it switches on again (auto-start).
•
On the outlet of the compressor, there is a lower pressure. What remains is the pressure that
you work with. The operating pressure may vary according to the connected airbrush gun.
Operating the pressure regulator with filter
a) Pressure regulator
b) Pressure gauge
c) Water drain plug
Product name:
Pressure regulator with filter and manometer
Type:
AFR-2000
