9
10
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [email protected]. Hours: 7 am to 6 pm MST.
Point antennas away from each other
CORRECT INSTALLATION
Never point antennas toward each other
INCORRECT INSTALLATION
Figure 1
Figure 2
Signal Booster
Signal Booster
Outdoor
Antenna
Outdoor
Antenna
Inside Panel
Antenna
Inside Panel
Antenna
During installation mode the Signal Booster is resetting itself very quickly
to aid the installer . The Signal Booster is equipped with three indicator
lights, one for each band . Within the first 15 minutes that the Signal
Booster is plugged in, it is programed for a test and alignment period .
1. BLINkING GREEN
If the Signal Booster light is blinking green, the Signal Booster is
operating properly . If you are happy with the coverage area in your
building, then you are done . Blinking will stop after the 15 minute
installation period .
2. BLINkING ORANGE
If the light on the Signal Booster is blinking orange, the Signal Booster
is experiencing receiver (cell tower) overload . The Signal Booster has
reduced the gain to prevent the disruption of cell towers . If the light is
Understanding the Signal Booster Lights and
Troubleshooting
Note:
If after the initial 15 minutes you are not done with the
installation, the Signal Booster can be reset and enter installation mode
again by disconnecting and reconnecting the power supply from the
Signal Booster.
For the first 15 minutes the three
indicator lights will do one of the
following 4 things:
