Installation & Operation Manual
Stainless Steel 180° Washfountain
WWF-4203-PSL-FT / WWF-4204-PSL-FT
Willoughby Industries, Inc.
TOLL FREE
(800) 428-4065
● LOCAL
(317) 875-0830
● FAX
(317) 875-0837
Page 7
Rev. 1/2019
www.willoughby-ind.com
Installation Instructions
Step 1: Pedestal Mounting*
Parts supplied:
• Pedestal/Basin/Backsplash assembly (pre-assembled)
Note: Hardware for wall and floor anchoring by others
*
For details on Step 1 instructions, see *
WWF-4203/4204-PSL-FT
Assembly Drawing
on Page 10
1.) Unpack Pedestal/Basin/Backsplash assembly and inspect parts.
2.) Place included rough-in template(s) at the desired position and mark anchor holes.
Make sure
that the intended anchor locations will provide adequate backing to support the installed
washfountain. If adequate backing does not exist, install appropriate support backing or
relocate unit before proceeding with installation
(backing provided by others).
3�) Secure the included Z-clips using anchors that are adequate for the type of wall (anchors by
others)�
4.) With assistance, lift the assembly over and carefully fit into the installed wall Z-clips.
5�) Align the frame mounting holes on the lower section of the assembly with the anchor holes
marked in previously in Step 2. Secure the assembly to the wall using anchors that are
adequate for the type of wall (anchors by others)�
6.)
Secure assembly to floor using appropriate floor anchors (anchors by others).
