Installation & Operation Manual
Stainless Steel 360° Washfountain
WWF-3606-PSL-FT
Willoughby Industries, Inc.
TOLL FREE
(800) 428-4065
● LOCAL
(317) 875-0830
● FAX
(317) 875-0837
Page 9
Rev. 8/2021
www.willoughby-ind.com
Installation Instructions
Parts supplied:
• Pedestal/Wash Basin assembly (pre-assembled)
Note: Hardware for floor anchoring by others
1.) Unpack pedestal and inspect parts.
2.) Place pedestal at the desired position and mark anchor holes (anchors by others).
Make sure that the intended anchor locations will provide adequate backing to support the
installed washfountain. If adequate backing does not exist, install appropriate support backing
or relocate unit before proceeding with installation
(backing provided by others).
3.) Secure the pedestal to the floor using anchors that are adequate for the type of floor.
Step 1: Pedestal Mounting
Step 2: Drain Assembly
Parts supplied:
• Pedestal/Wash Basin assembly (pre-assembled)
• Drain assembly (
see diagram
)
1�) Insert the drain assembly down through the basin drain hole�
2.)
Secure in place by fitting the rubber and stainless steel
washers onto the drain assembly from the underside of the
basin and tightening the locknut onto the drain assembly,
sandwiching the washers between the basin and locknut.
Note: Over-tightening can damage the basin and/or
drain assembly components
