6
WIR TX75 PRO Infrared Transmitter
Installation Procedures
determine Coverage Area
When using the WIR TX75 PRO transmitter in single-channel mode with the RX22-4 receiver, the system coverage area will
exceed 5000 ft² (185 m²). WIR TX75 PRO units automatically adjust to give the best coverage area possible in both 1-channel and
2-channel modes.
Figure 1 illustrates typical coverage pattern for the TX75. This can be affected by direct/indirect sunlight, reflections on walls and
room construction. Reflections of the infrared light from walls, ceilings, and floors may change these patterns.
Important: Remember to point the transmitter towards the listening audience.
Remember: Most objects block infrared light. The transmitter cannot be concealed behind walls, glass, curtains, etc.
These patterns are the direct radiation pattern. The infrared radiation does not drop to zero outside the illustrated patterns; it
decreases. It still may be useable at a greater distance, depending on the receiver sensitivity and the reflective characteristics of
the room. Reflections of the infrared light from walls, ceilings, and floors may change these patterns.
The TX75 can be operated with or without the faceplate, if desired. The faceplate can be removed and painted to match room
decor. Lightly sand faceplate with 400 grit sandpaper apply primer and two coats of final color.
Do not paint the infrared lens
behind the faceplate of the TX75.
figure 1: Receiver coverage area with WIR TX75 PRO transmitter OR WIR TX75-S slave emitter in single channel mode.
0
10
20
30
40
RX22-4 RECEIVER
RX18 RECEIVER
RX15-2 RECEIVER
0
10
20
30
40
50
60
70
80
90
100
110
120
130
140
150
160
170
A157
FEET
