®
11
W
IDEBAND
FM R
ECEIVERS
(O
PTIONAL
)
R
ECEIVER
M
ODEL
PPA R35
The PPA R35 is a single-channel receiver operating on the 72-76 MHz bandwidth. It features
volume on/off control, LED power and low battery indicator, and an earphone jack (see Fig. 7).
Instructions:
B
ATTERY
I
NSTALLATION
Install two (2) AA alkaline or NiMH rechargeable batteries. Open the battery compartment by
lifting the tab on the back of the receiver with a finger. To remove depleted batteries, pull up on
the fabric strip. IMPORTANT: If Alkaline (non-rechargeable) batteries are being installed, slide
the battery selection switch above the battery compartment to the “Alkaline” position. If
installing NiMH (or rechargeable) batteries, slide the battery selection switch to the “NiMH”
position. Press the batteries into place over the fabric strip. Be sure to observe proper polarity
(+/-). Damage due to improper battery installation may void the warranty on the product. Close
the battery door. When the sound becomes weak or distorted, replace or recharge the batteries.
NOTE: The ON indicator will illuminate RED to indicate low battery.
C
ONNECTING
E
ARPHONES
Plug the earphone into the “EAR” jack on the top of the unit. Only monophonic earphones will
operate properly. If stereo headphones are used, sound will be heard only in one side. Williams
Sound evaluates each earphone and headphone used with the PPA R35 receiver; we can only
assure optimum performance when Williams Sound earphones and headphones are used.
O
PERATING THE
R
ECEIVER
NOTE: Check to make sure the T35 transmitter is on and receiving good audio input. Also, make
sure the T35 is operating in Wideband mode, and transmitting on the same frequency as the
receiver. If the R35 receiver needs to be re-tuned (most Williams Sound receivers are set at the
factory at 72.9 MHz), see page 12 for frequency change instructions.
Turn the receiver on by rotating the volume control knob clockwise. The receiver’s ON indicator
should illuminate green. Adjust the volume control for your comfort. To turn the receiver off,
rotate the volume control knob counter-clockwise until it clicks off. The receiver’s ON indicator
should go dark.
To maximize battery life, remember to turn the receiver off when it’s not in use.
R35 Front
R35 Top
On/Off
Volume Switch
Earphone
Jack
"On" Indicator
LED
R35 Front
R35 Top
On/Off
Volume Switch
Earphone
Jack
"On" Indicator
LED
F
IG
. 7
R35 Top
R35 Front
